The most common problems with DHCP usually aren't related to the server; after the server is configured correctly there is no need to change any settings and it therefore runs reliably. The problems usually occur at the DHCP client's end for a variety of reasons. The following sections present simple troubleshooting steps that you can go through to ensure that DHCP is working correctly on your network.
DHCP Clients Obtaining 169.254.0.0 Addresses
Whenever Microsoft DHCP clients are unable to contact their DHCP server they default to selecting their own IP address from the 169.254.0.0 network until the DHCP server becomes available again. This is frequently referred to as Automatic Private IP Addressing (APIPA). Here are some steps you can go through to resolve the problem:
1.
Ensure that your DHCP server is configured correctly and use the pgrep command discussed earlier to make sure the DHCP process is running. Pay special attention to your 255.255.255.255 route, especially if your DHCP server has multiple interfaces.
2.
Give your DHCP client a static IP address from the same range that the DHCP server is supposed to provide. See whether you can ping the DHCP server. If you cannot, double-check your cabling and your NICs.
